Operating the Dishwasher
Start the dishwasher
1 Open the door and press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options.
3 Press [Start] and close the door to begin the cycle.
Cancel a cycle
1 Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2 Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
3 Close the door and wait about I minute while the dishwasher drains.
4 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2 Press the [On/Off] button to turn the unit off.
3 To resume the cycle, press the On/Off button and close the dishwasher door.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:O0" to "r:06".
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:O0".
3 Release both buttons.
4 Press the "A" button until the display shows "r:05".
5 Press the "C" button to select the desired setting.
"r:O0" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
6 Press [Start] to save the setting and close the door.
InfoLight
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level,the LED isnot visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:O0".
3 Release both buttons.
4 Press the "A" button until the display shows "1:01".
5 Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Open the door and press the [On/Off] button.
2 Press the [+] button until the display jumps to "h:01".
3 Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = :Lhour delay
h:24 = 24 hour delay
4 Press [Start] to activate delay start.
To cancel delay start:
1 Press the [+] or [-] button until "h:O0" is indicated on the digital display.
2 Press [Start] to save setting and close the door.
13
To Next Page
Loading...
