en-us Basic Operation
32
Basic Operation
13 Basic Operation
Basic Operation
13.1 Protection against
unintentional
operation
Your appliance is equipped with a
function that helps to prevent un-
intentional operation, e.g. by chil-
dren. After starting the appliance,
the door has to be closed within 4
seconds, otherwise the operation
will be paused.
Note:This function cannot be de-
activated.
Requirements
¡ Pressing Start to begin a wash
cycle
¡ Setting Delay time and press-
ing Start
¡ Opening the door while Delay
time is active
¡ Opening the door during a
wash cycle.
1. Close the door.
2. Press .
a The wash cycle will resume.
13.2 Switching on the
appliance
▶ Press .
The program last selected and
the additional function last se-
lected will be set by default.
If you do not perform any ac-
tions on the appliance for 10
minutes, it will automatically
switch off.
13.3 Setting a cycle
To adjust the wash cycle to the
soiling level of the dishware, se-
lect a suitable programme.
▶ Press the right cycle button.
a The cycle is set and the cycle
button flashes.
a The remaining run time of the
cycle appears on the display.
13.4 Setting options
You can set options to complete
the chosen wash program.
Note:The available options de-
pend on which program is se-
lected.
▶ Press the button for the rele-
vant option.
a The option is set and the option
button flashes.
13.5 Setting the electronic
delay time
You can delay the start of the
wash cycle by up to 24hours.
1. Press .
a "00h:01m" appears on the dis-
play.
2. Use to set the required
start time for the wash cycle.
3. Press .
a This activates the electronic de-
lay time.
Note:To deactivate the electronic
delay time, press repeatedly
until "00h:00m" appears on the
display.
13.6 Starting the wash
cycle
▶ Press .
a The wash cycle has ended
when the display shows
"00h:00m".
To Next Page
Loading...
Need help?
General
