en-us Troubleshooting
50
Issue Cause and troubleshooting
Plastic parts are dis-
colored.
Dishwashing temperature is too low.
▶ Select a program with a higher dishwashing
temperature.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
▶ Only remove large remnants of food and do not
pre-rinse dishware.
▶ Adjust the sensitivity of the sensors.
→
"Sensors", Page10
There are remov-
able streaks on
glasses, glassware
with a metallic ap-
pearance and silver-
ware.
Amount of rinse aid to be dispensed is set too
high.
▶ Set the rinse aid system to a lower setting.
No rinse aid has been added.
▶
→
"Adding rinse aid", Page25
There is detergent residue in the final rinse. Lid of
detergent dispenser is blocked by dishware and
will not open fully.
1. Arrange dishware in the upper rack so the tab
collecting tray is not obstructed by dishware.
→
"Loading dishware", Page30
Items of dishware are blocking the dispenser
lid.
2. Do not place dishware or fragrance dispensers
in the tab collecting tray.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
▶ Only remove large remnants of food and do not
pre-rinse dishware.
▶ Adjust the sensitivity of the sensors.
→
"Sensors", Page10
To Next Page
Loading...
Need help?
General
