en Troubleshooting
42
Fault Cause and troubleshooting
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
▶ Only add detergent to a detergent dispenser when
dry.
Excessive formation of
foam occurs.
Hand washing-up liquid is present in dispenser for
rinse aid.
▶ Immediately add rinse aid to the dispenser.
→"Adding rinse aid", Page23
Rinse aid has been spilled.
▶ Remove the rinse aid with a cloth.
Detergent or appliance care product used causes ex-
cessive foaming.
▶ Change the brand of detergent.
Fault Cause and troubleshooting
Special salt refill indic-
ator lights up.
Insufficient special salt.
▶
Add Special salt →Page21.
Sensor does not detect special salt tablets.
▶ Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up.
Water softening system is switched off.
▶
Setting the water softening system →Page21
Refill indicator for
rinse aid lights up.
Insufficient rinse aid.
1.
Add Rinse aid →Page23.
2. Set the amount of rinse aid to be dispensed.
Refill indicator for
rinse aid does not
light up.
Rinse aid system is switched off.
▶ Set the amount of rinse aid to be dispensed.
→"Setting the amount of rinse aid", Page23
→"Setting the amount of rinse aid", Page23
Fault Cause and troubleshooting
Water is left in the ap-
pliance at the end of
the programme.
Filter system or area under the filters is blocked.
1.
Clean the Filters →Page32.
2.
Clean the Wastewater pump →Page45.
Programme has not yet ended.
▶ Wait until the programme ends or cancel the pro-
gramme with Reset.
▶
→"Terminate programme", Page30