Need help?Do you have a question about the Bosch SMD6TCX00E and is the answer not in the manual?
General| Door color | Not applicable |
|---|---|
| Cord length | 1.75 m |
| Product size | Full size (60 cm) |
| Built-in display | Yes |
| Inlet hose length | 1.65 m |
| Custom panel-ready | - |
| Outlet hose length | 1.9 m |
| Appliance placement | Fully built-in |
| Current | 10 A |
| Connected load | 2400 W |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Energy efficiency scale | A to G |
| Water consumption per cycle | 9.5 L |
| Cycle time | 295 min |
| Noise level | 44 dB |
| Drying system | Zeolite |
| Delay start (max) | 24 h |
| Dishwashing programs | Auto 45-65°C, Eco 50°C, Favorite, Intensive 70°C, Pre-rinse, Silent 50°C |
| Number of place settings | 14 place settings |
| Number of washing programs | 6 |
| Feet adjustment | 60 mm |
| Package weight | 45000 g |
Weight and Dimensions| Depth | 550 mm |
|---|---|
| Width | 598 mm |
| Height | 815 mm |
| Weight | 42700 g |
| Depth with door open | 1150 mm |
| Installation compartment width | 600 mm |
| Installation compartment height (max) | 875 mm |
Read the manual carefully and keep it for future reference or the next owner.
Use this appliance for cleaning household tableware in private households and enclosed spaces.
Follow manual and installation instructions to prevent injury from improper installation.
Improper installation may cause damage. Follow instructions and check water pressure.
Escaping water vapour can damage units. Special salt can damage the tub. Use suitable cleaning agents.
Follow safety, electrical, drainage, and water connection instructions. Ensure appliance is level.
Connect to drainage for dirty water discharge. Ensure wastewater hose is not kinked.
Connect to drinking water supply. Use new hose if replacing. Ensure connection is not kinked.
Connect to alternating current (220-240V, 50/60Hz). Ensure mains plug is inserted properly.
Configure settings for start-up: water hardness, salt, rinse aid, detergent. Run initial programme.
Set water hardness on appliance by determining hardness and selecting appropriate value in basic settings.
Use special dishwasher salt to soften water. Add salt to dispenser before programme starts.
Use rinse aid for optimum drying. Only use for domestic dishwashers. Add if indicator lights up.
Use dishwasher-suitable detergents (separate/combined). For best results, use separate, salt, and rinse aid.
To Next Page
