Bosch SMI2HTB02G User Manual

en Rinse aid system
26
Additional power consump-
tion in kWh
0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard using the Eco
50° programme and with the factory
value of the water hardness set to 16
- 20°E.
Rinse aid system
11 Rinse aid system
Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
1. Press the catch on the lid of the
dispenser for rinse aid and lift
⁠.
1
2
2. Add rinse aid up to the max mark.
max
3. If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4. Close the lid of the dispenser for
rinse aid.
a The lid clicks into position.
11.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1. Press ⁠.
2. To open the basic settings, press
for 3 seconds.
a The display shows Hxx.
a The display shows ⁠.
3. Press repeatedly until
the display shows the value r05
set at the factory.
4. Press repeatedly until the
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.

Bosch SMI2HTB02G Specifications

General

Brand	Bosch
Model	SMI2HTB02G
Category	Dishwasher
Language	English