Troubleshooting en
45
Fault Cause and troubleshooting
All LEDs lit up or
flashing.
Electronics have detected a fault.
1. Press the main switch button for approx.
4seconds.
The appliance is reset and restarted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Pull out the mains plug or switch off the fuse in
the fuse box.
‒ Wait at least 2minutes.
‒ Switch on the fuse in the fuse box or insert the
mains plug.
‒ Switch the appliance on.
3. If the problem occurs again:
‒ Contact customer service.
→"Customer Service", Page49
Remnants of food on
tableware.
Tableware is placed too close together or basket is
overfilled.
1. Arrange tableware with sufficient space in between.
The spray jets must reach the surfaces of the table-
ware.
2. Avoid points of contact.
Spray arm rotation is blocked.
▶ Arrange tableware so that it does not obstruct
spray arm rotation.
Spray arm nozzles are blocked.
▶
Clean the Spray arms →Page40.
Filters are soiled.
▶ Clean the filters.
→"Cleaning filters", Page39
To Next Page
Loading...
Need help?
General
