EasyManua.ls Logo

Bosch SMI43M15EU - Timer Programming; End of Programme; Switching Off Automatically; Switching Off the Appliance

Bosch SMI43M15EU
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Operating the appliance
22
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button @ + until the digital
display )" jumps to œ:‹‚.
4. Press @ + or – button until the
displayed time corresponds with your
requirements.
5. Press START button P, timer
programming is activated.
6. To delete timer programming, press
the @ + or – button until )" œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value :‹‹ is indicated on the numerical
display )".
Switching off automatically
after the end of
the programme *
Switching off automatically after the end of the programme
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until :... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display )" displays the
factory setting :‹….
5. Press programme button # until
the factory set value ˜:‹‚
is indicated on the digital
display )".
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of ˜:‹ƒ has been
reached, the display jumps back
to ˜:‹‹ (off).
2. Press START button P.
The set value is saved.
Switching off the appliance
Short time after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off the tap (not applicable if
Aqua-Stop fitted).
3. Remove the utensils when they have
cooled down.
Note
When the programme ends, leave
the appliance to cool down a while
before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min

Table of Contents

Related product manuals