en Operating the appliance
28
Here is how to change the setting:
1. Switch on the ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button P until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display )" lights up
to show the value •:‹....
4. Press the programme button #
repeatedly until the value ˜:‹...
appears in the display window )".
5. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value ˜:‹,ƒ the
display jumps back to ˜:‹‹.
6. Press START button P.
The set value is saved.
* depending on the features of your
dishwasher
Switching off the appliance
Shortly after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off water supply (does not
apply to appliances with Aqua-Stop).
3. Remove the utensils when they have
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
To Next Page
Loading...
