Bosch SMS68M02AU - Interrupting the Programme; Terminating the Programme (Reset); Changing the Programme; Intensive Drying

aus
15
Interrupting the programme
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection or
is heated, first leave the door ajar for
several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch on
the ON/OFF switch
1
again.
Terminating the programme
(Reset)
Press START button
6
for approx.
3 sec.
The numerical display
9
indicates
.
The programme sequence lasts
approx. 1 min.
On the digital display
9
is indicated
.
Switch off ON/OFF switch
1
.
Changing the programme
When the START button
6
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (reset).
Intensive drying
The final rinse uses a higher temperature
which improves the drying result.
The running time may increase slightly.
(Caution if utensils are delicate!)
Close the door.
Switch on ON/OFF switch
1
.
Hold down programme button A and
press START button
6
until on the
digital display
9
is indicated .
Release both buttons.
To change the setting,
Press the button C to switch
intensive drying on
or off .
Press START button
6
.
The set value is saved.