Bosch SMV2HTX02G - 15.1.1 Setting Extra Dry; 15.1.2 Setting signal volume

en Basic settings
34
Basic setting Selection Description
Remote Start Scale with 3 levels Activate or deactivate the
function.
→"Activating Remote
Start ", Page35
This basic setting is not
available until you have
connected the appliance
with the HomeConnect
app.
→"HomeConnect ",
Page35
Factory setting Reset Restore changed set-
tings to the factory set-
tings.
The settings for initial
start-up must be con-
figured.
→"Restoring factory set-
tings", Page35
1
Factory setting (may vary according to model)
Setting Extra Dry
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes.
3. Press repeatedly until
and flash.
4. Press repeatedly until the
LEDs show the right value.
A
If LED A is not lit up, Extra Dry is
switched off.
If LED A is lit up, Extra Dry is
switched on.
5. To save the settings, press
for 3 seconds.
Setting signal volume
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes.
3. Press repeatedly until
and flash.
4. Press repeatedly until the
right signal volume has been set.
A CB
0, 1, 2 or 3 LEDs will light up ac-
cordingly. The signal tone selected
will be heard.
The factory setting is level 2 (LED
A and LED B).
5. To save the settings, press
for 3 seconds.