Bosch SMV2HTX02G - Page 43

Troubleshooting en
43
Fault Cause and troubleshooting
Display "Check water
supply" flashes
A technical fault is present.
1. Press .
2. Unplug the appliance or switch off the fuse.
3. Wait at least 2minutes.
4. Insert the mains plug of the appliance in a socket
or switch on the fuse.
5. Switch the appliance on.
6. If the problem occurs again:
‒ Press ⁠.
‒ Turn off the water tap.
‒ Pull out the mains plug.
‒ Contact Customer Service →Page48 and give
the error code.
Displays flash Appliance door is not closed properly.
▶ Close the appliance door.
‒ Arrange the tableware so that no parts project
beyond the basket and prevent the appliance
door from closing properly.
All LEDs lit up or
flashing.
A software update is possibly installing.
1. Wait until the software update has been installed.
This process can take approx. 30minutes.
2. If the appliance is not ready to use after
30minutes, perform a reset.
‒ Press the main switch button for approx.
4seconds.
a Your appliance is resetting.
Electronics have detected a fault.
1. Press the main switch button for approx.
4seconds.
The appliance is reset and restarted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Pull out the mains plug or switch off the fuse in
the fuse box.
‒ Wait at least 2minutes.
‒ Switch on the fuse in the fuse box or insert the
mains plug.
‒ Switch the appliance on.
3. If the problem occurs again:
‒ Contact customer service.
→"Customer Service", Page48