Bosch SMV2ITX48E - Rinse Aid System; Rinse Aid; Setting the Amount of Rinse Aid

Rinse aid system en
25
Rinse aid system
11 Rinse aid system
Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
1. Press the catch on the lid of the
dispenser for rinse aid and lift
⁠.
1
2
2. Add rinse aid up to the max mark.
max
3. If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4. Close the lid of the dispenser for
rinse aid.
a The lid clicks into position.
11.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes.
3. Press repeatedly until
flashes.
4. Press repeatedly until the
right amount of rinse aid has been
set.
A CB
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
The factory setting is level 2
(LEDA and LEDB →Page15).
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
5. To save the settings, press
for 3 seconds.