Bosch SMV46MX03E - Programme Control and Interruption

Operating the appliance en
31
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display h lights up
to show the value •:‹....
4. Press the programme button #
repeatedly until the value ˜:‹...
appears in the display window h.
5. Press the programme button 3.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value ˜:‹ƒ the
display jumps back to ˜:‹‹.
6. Press START button `.
The set value is saved.
* depending on the features of your
dishwasher
Switching off the appliance
Shortly after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off water supply (does not
apply to appliances with Aqua-Stop).
3. Remove the utensils when they have
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
2. Switch on the ON/OFF switch (
again to continue the programme.
Terminating the programme
(Reset)
Terminating the programme 1. Open the door.
2. Press the START button ` and
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window h.
3. Close the door. The programme
sequence lasts about 1 minute.
The value ‹:‹‹ appears in the
display window h.
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.
Changing the programme
When the START button ` has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).