Installation and connection en
47
Warm water connection*
Hot water connection
* depending on the configuration of
your specific dishwasher
The dishwasher can be connected to
cold or hot water up to max. 60°C.
Connection to hot water is
recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with
circulation line. This will save energy
and time. The hot water setting ‘:‹‚
allows you to adjust your appliance
optimally to operation with hot water. It
is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C and
no more than 60 °C. It is not
recommended to connect the appliance
to hot water if the water is supplied from
an electric boiler.
Here’s how to change the hot water
setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the digital display h lights up
to show the value •:‹....
4. Press the programme button #
repeatedly until the factory setting
value ‘:‹‹ appears in the display
window h.
5. By pressing the 3 button, you can
switch the hot water setting off ‘:‹‹
or on ‘:‹‚.
6. Press START button `.
The set value is saved.
To Next Page
Loading...
