Interrupting the programme
• Switch off ON/OFF switch, the LEDs go out. The programme is saved.
• If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar
for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring
open or water to run out of the appliance.
• To continue the programme, switch on the ON/OFF switch again.
Terminating the programme (Reset)
• Open the door.
• Press START button [9] for approx. 3 sec. until all displays go out.
• Close the door. The remaining programme sequence for draining the residual water takes approx. 1 minute.
To Previous Page
Loading...
