What to do if my Bosch T2400S 8 ND 23 Water Heater indicates a gas valve wrong connection?
If a safety solenoid from the gas valve is disconnected, it indicates a gas valve wrong connection. The error is resolved by performing a manual reset.
What to do if my Bosch Water Heater has exhaust blockage?
If the fan speed and/or consumption detect a pressure above normal operating conditions on the exhaust, check configuration parameters like AS (altitude), F9 (flue exhaust code), AP (appliance power), etc.
What to do if my Bosch Water Heater shows temperature limiter or thermal fuse opened circuit?
This error occurs if the temperature limiter detects a temperature over 85ºC, or if the thermal fuse contact opens (192ºC) due to overheating and malfunction of the temperature limiter. The error is resolved by manually resetting the system after the temperature limiter cools down and the contact closes again.
Why does my Bosch Water Heater display a water flow signal over specified maximum value?
This error occurs when the water flow exceeds 22 l/min. The error is resolved when the water flow is below this value again.
What causes an exhaust blockage error in my Bosch T2400S 8 ND 23?
If pressure above normal operating conditions is detected, it indicates an exhaust blockage. The error is resolved by performing a manual reset.
What does MCU RAM DC internal error mean for my Bosch T2400S 8 ND 23?
If voltage is too low (less than 70 V ac), it triggers an MCU RAM DC (micro controller) internal error. The error is resolved by performing a manual reset.
What does it mean when my Bosch Water Heater displays MCU RAM DC (micro controller) internal error?
Check if the voltage is too low (less than 70V AC). This error is resolved by a manual reset. If the voltage is okay and the error persists, replace the control unit.
Why does my Bosch T2400S 8 ND 23 Water Heater show an error related to the temperature limiter or thermal fuse?
If the temperature limiter detects a temperature over 85ºC, it causes the temperature limiter or thermal fuse to open the circuit. This error is resolved by manually resetting the system after the temperature limiter cools down and the contact closes again.
What to do if my Bosch T2400S 8 ND 23 Water Heater displays an internal checking failure?
This error is resolved by a manual reset. If the error persists, replace the control unit.
What to do if my Bosch T2400S 8 ND 23 remote controller removes the error code 5 times continuously within 15mins?
This error is resolved by a manual reset.
General| Brand | Bosch |
|---|---|
| Model | T2400S 8 ND 23 |
| Type | Tankless |
| Fuel Type | Electric |
| Maximum Inlet Water Temperature | 140°F |
| Power Source | Electric |
| Flow Rate | 2.4 GPM |
| Venting | Not applicable |
To Next Page