19
TES502 | 02/2013
19en
Problem Cause Solution
Coffee is too “acidic”. The grinding setting is too
coarse or the pre-ground
coffee is too coarse.
Adjust the grinding unit to
a ner setting or use ner
pre-ground coffee.
Unsuitable type of coffee Use a darker roast.
Coffee is too “bitter”. The grinding setting is
too ne or the pre-ground
coffee is too ne.
Adjust the grinding unit to
a coarser setting or use
coarser pre-ground coffee.
Unsuitable type of coffee. Change type of coffee used.
Display shows
Error
Call hotline
The appliance has a fault. Please call the hotline.
The water lter does not
stay in position in the water
tank (16).
The water lter is not
mounted correctly.
Firmly press the water lter
straight down into the tank
connection.
The coffee grounds are not
compact and are too wet.
The grinding setting is too
ne or too coarse, or not
enough ground coffee has
been used.
Adjust the grinding unit to
a coarser or ner setting,
or use 2 level measuring
spoons of ground coffee.
Display shows
Clean brewing unit
Brewing unit (5) is soiled. Clean brewing unit (5).
Too much pre-ground cof-
fee in the brewing unit (5).
Clean brewing unit (5)
(pour in no more than 2
level measuring spoons of
ground coffee).
The brewing unit’s
mechanism is stiff.
Remove and clean the
brewing unit, see “Mainte-
nance and daily cleaning”.
Coffee or milk froth quality
varies considerably.
Build-up of limescale in the
appliance.
Descale the appliance with
two descaling tablets as
described in the instructions.
Water dripped onto the
inner oor of the appliance
when the drip tray (8) was
removed.
Drip tray (8) removed too
early.
Wait a few seconds after
the last drink was dispensed
before removing the drip
tray (8).
If you are unable to solve the problem, please call the hotline.
TES502_1RW.indb 19 21.02.2013 13:38:24
To Next Page
Loading...
