EasyManuals Logo

Bosch TR1000 4 T User Manual

Bosch TR1000 4 T
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Safety information
TR1000 4 T, TR1000 5 T, TR1000 6 T, TR1000 6 B – 6 720 876 020 (2020/06)
18
material damage and personal injury,
including possible loss of life.
Read the installation instructions
(heat source, heating controller, etc.)
before installation ( chapter 3).
Observe the safety instructions and
warnings.
Observe national and regional
regulations, technical rules and
guidelines.
The continuous-flow heater may
only be connected and put into
operation by a qualified
professional.
In order to avoid potential sources
of danger, repairs and maintenance
may only be undertaken by a
suitably qualified specialist.
Improper repairs can lead to risk of
serious injury to the user.
Never open the appliance without
disconnecting the power supply
beforehand.
The statutory regulations of the
respective country, as well as those of
the local electricity and water
suppliers, must be adhered to.
IEC 600364‑7‑701 (DIN VDE0100,
par 701) must be observed when
installing the appliance and/or
electrical accessories.
The continuous-flow heater is a Class I
appliance and must be connected to
the protective earth.
The appliance must be permanently
connected to the electrical
connections (TR1000 5T, TR1000
6T, TR1000 6B). The conductor
cross-section must comply with the
installed appliance power.
CAUTION:
Earthed water pipes may give the
appearance of a connected protective
earth.
To guarantee compliance to relevant
safety regulations, an all-pole
separator must be fitted during
installation, according to chapter 4.
The contact opening must be at least
3mm.
Ensure that the inlet water pressure,
maximum and minimum, is according
with the value specified by the
manufacturer ( chapter 4).
The water inlet of this appliance shall
not be connected to inlet water
obtained from any water heating
system.
Do not use plastic pipes. Steel or
copper pipes are suitable for the cold-
water supply. Insulated copper pipes
are particularly suitable for the hot-
water pipes.
Disconnect the electrical
connection cable from the supply
and shut off the water supply
before connecting the appliance!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch TR1000 4 T and is the answer not in the manual?

Bosch TR1000 4 T Specifications

General IconGeneral
BrandBosch
ModelTR1000 4 T
CategoryWater Heater
LanguageEnglish

Related product manuals