Bosch TS2000 - Stand Assembly Hardware

-3-
*Note: There are two (2) 8mm x 50mm Phillips head screws and two (2) 8mm lock nuts to be
used only when attaching other branded table saws to the Bosch TS2000 stand. See page 6
for instructions.
STAND ASSEMBLY HARDWARE
(packaged in one bag)
Item
Qty. Part Description
G 6 10mm x 100mm Hex Head Bolts
H 2 10mm x 50 mm Hex Head Bolts
I 6 8mm x 50 mm Phillips Head Screws*
J 18 10mm Flat Washers
K 2 10mm Star Washers
L 6 10mm Lock Nuts
M 6 8mm Lock Nuts*
N 4 6mm x 75mm Hex Head Bolt
O 8 6mm Flat Washer
P 4 6mm Lock Nuts
GHI
J
K
L
M
N
O
P