To level stand
The stand is equipped with two adjustable
feet for leveling the stand.
To adjust: loosen wing nut and adjust the
height of the foot by screwing the threaded
shaft clockwise to raise foot or counter-
clockwise to lower foot. Retighten wing nut
securely.
To reduce the risk of injury,
periodically check that all
fasteners are attached and adjusted
according to the assembly instructions
included in this manual.
Tire Pressure
The TS2000 tires are shipped with an air
pressure of 25 to 30 P.S.I. — an adequate
pressure for most working conditions. If you
wish to increase the tire pressure for a
slightly firmer support, you may inflate the
tires to a maximum of 50 P.S.I. It is
recommended that a hand pump is used.
-8-
Operating Instructions
Maintenance
!
WARNING
To Next Page
Loading...
Need help?
General
