FlexiDome
VF
| Installation Manual
Bosch Security Systems | 2005-11 | V1.0
EN | 11
Figure 4 Surface mounting - rear connection
Raised mounting
When using the surface mounting box:
• With a side connection, remove the cap covering the side entrance.
With a rear connection, leave the cap in place.
• Attach the conduit to the mounting base.
• Make the connection inside the mounting case.
Cap
Three screws
(M5, supplied)
Surface
mounting box
(VDA-445SMB)
Conduit
Three screws
(supplied with
camera)
Camera unit
and base
Solid surface
(three pre-drilled
8mm holes)
Wires
To Next Page
Loading...
