To Next Page
C
Chad BrennanJul 26, 2025
What to do if there is no video on Bosch Media Converter?
- KKristin WilsonJul 26, 2025
If there's no video, start by checking the PWR/Link on the VG4-SFPSCKT. If the LED is slowly flashing red, check all video connections from the VG4 AutoDome. If the LED is rapidly flashing red, check the RJ-45 connector on the VG4-SFPSCKT; if the right LED (Green) is not lit, no data is present at this RJ-45 connection. If no LED is lit on the RJ-45 connector, there is a fault with this connector, the RJ-45 cable, or the cable is not connected to the CNFE2MC. Also, check the RJ-45 connector on the CNFE2MC; if the right LED (Green) is not lit, no data is present at this RJ-45 connection. If no LED is lit on the RJ-45 connector, then there is a fault with this connector, the RJ-45 cable, or the cable is not connected to the VG4-SFPSCKT.
General
