AutoDome Modular Camera System VG4 Firmware Updates via a TCP/IP Network | en 1
Bosch Security Systems, Inc. Firmware Update Manual F01U096914 | 1.05 | 2008.10
1 VG4 Firmware Updates via a TCP/IP Network
The IP AutoDome® incorporates a network video server in the IP module. The primary function
of the server is to encode video and control data for transmission over a TCP/IP network. The
IP AutoDome also allows an operator to update the AutoDome firmware via the TCP/IP
network. This chapter applies to a VG4 100, 200, 300, or 500i Series AutoDome with an IP
Communications Module.
Refer to the AutoDome Modular Camera System Installation Manual, the 100 Series User’s Manual
and the 200, 300, 500i Series User’s Manual for specific instructions on configuring the IP
AutoDome camera.
The latest VG4 service pack is available on the Bosch Security Systems Web site. To download
the service pack from the Web, navigate to www.boschsecurity.us, click the CCTV link, then
click Software under the Download Library heading. Then click on CCTV, and Cameras, PTZ to
display the list of AutoDome models with Firmware updates.
1.1 Upgrading the IP AutoDome
Use the following instructions to update the CPU or IP communications module firmware to an
IP AutoDome over a TCP/IP network. To update firmware on a non-IP AutoDome see
Section 2 VG4 Firmware Updates via the CTFID, page 11.
1.1.1 Minimum Requirements
The table below summarizes the information for the first full production versions of the VG4
AutoDome firmware.
If the AutoDome receiving an upgrade contains firmware older than the files above, then the
AutoDome is considered a pre-production model. Service packs may not properly update a
pre-production model. If you do need to update a pre-production model, follow the special
instructions in Section 3.1 Pre-production Firmware Versions (All Models), page 27.
CAUTION! If a service pack contains an upgrade to the IP firmware file (Vip_x_app1.fw), you
must upgrade the IP firmware before you perform any other firmware update. (For example,
before uploading SCBootApp.g4i or SCMain.g4i).
Component First Released Version Release Date
SCBootApp.g4i 01.00.00.01 November 2006
SCMain.g4i 01.00.00.02 November 2006
VCA_App.g4i 01.00.00.01 April 2007
VCA_boot.g4i 00.06.00.00 April 2007
vip_x_app1.fw 2.00.00.58 November 2006
To Next Page
Loading...
Need help?
General
