What to do if my Bosch AUTODOME 7000 VG5-7230 Security Camera has no video?
First, ensure the main power to the power supply is on. Check if you have a web page. Verify there is 24 V output from the transformer. Finally, check the integrity of all wires and mating connectors to the camera.
Why is my Bosch Security Camera picture dark?
There could be several reasons why the picture is dark. Check that the Gain Control is set to High and the Auto Iris Level is set to the appropriate level via the Settings menu. Ensure that the camera lens cover is removed and that the maximum Ethernet cable distance has not been exceeded. You may also want to restore all camera settings via the Settings menu.
What to do if my Bosch AUTODOME 7000 VG5-7230 Security Camera has no network connection?
To troubleshoot a missing network connection, begin by checking all network connections. Ensure that the distance between any two Ethernet connections is 100 m (328 ft) or less. If you are behind a firewall, ensure that the Video Transmission mode is set to UDP via the Settings Web page under Service Settings, then Network. Select UDP from the Video Transmission drop-down list and click Set.
Why is the video rolling, noisy, or distorted on my Bosch AUTODOME 7000 VG5-7230?
To resolve video issues, check the frequency. From the SETTINGS page, click Advanced Mode, then Camera, and then Installer Menu. In the Base frame rate field, choose either 25 ips or 30 ips. Also, check the integrity of all connectors and splices of the Ethernet cable.
Why is there no camera control on my Bosch AUTODOME 7000 VG5-7230 Security Camera?
First, ensure that the LAN cable has a good and secure connection. Refresh the browser and ensure the video is updated. For analog cameras, cycle the camera's power off and on. For IP cameras, ping the camera’s IP address and try again to control the camera.
What to do if the image on the Bosch Security Camera flickers?
If the camera faces directly into the sun or fluorescent lighting, reposition the camera.
What to do if the contrast on the Bosch AUTODOME 7000 VG5-7230 screen is too weak?
If the camera is exposed to strong light, change the camera position.
Why does my Bosch AUTODOME 7000 VG5-7230 Security Camera move when moving other cameras?
If the camera’s IP address is not set, use Configuration Manager to confirm that two cameras do not have the same IP address.
What to do if I lose privacy when using Privacy Mask on my Bosch Security Camera?
To realign the mask back to its original position, press the FindHome key on the Special Functions menu or issue a SetScene 110 command.
What to do if the image on the Bosch Security Camera screen is dim?
If the lens is dirty, clean it with a soft, clean cloth.
Covers safety warnings, precautions, and important instructions for safe operation.
Details routing power, video, control, and alarm wires to the power supply box.
Steps for establishing a network connection between the camera and a PC.
Specifies the necessary software and hardware for camera configuration.
Details how to integrate the camera into an existing network in basic mode.
General| Ingress Protection | IP66 |
|---|---|
| Vandal Resistance | IK10 |
| Form Factor | Dome |
| Sensor Type | 1/2.8" CMOS |
| Resolution | 1920 x 1080 |
| Lens Type | Varifocal |
| Day/Night | Yes |
| WDR | 120dB |
| Video Compression | H.264, MJPEG |
| Audio Support | Yes (2-way audio) |
| Network Interface | 10/100 Base-T Ethernet |
| Power Supply | PoE+ (IEEE 802.3at) |
| Operating Temperature | +60°C |
| Camera Type | PTZ Dome |
To Next Page