Figure 10.8: In-ceiling (IP54 Rating) Installation Diagram
1
White Trim Ring (factory-installed on
dome bubble)
5 Inner Ring
2 Black Trim Ring (supplied in the
shipping box of the camera)
6 Ceiling (IP54 housing) Gasket
3 Bubble 7 In-ceiling housing
4 Trim Ring Gasket
1. Place the gasket (provided in the shipping box of the camera) over the top of the in-
ceiling housing.
2. Carefully slide the gasket down over the housing, until it rests on the flange of the
housing.
Attach Housing to the Interface Box
The In-Ceiling Housing is attached to the Interface Box and secured by two (2) thumbscrews.
9.8
AUTODOME 7000 Installing the In-Ceiling Mount | en 65
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679
To Next Page
Loading...
