Figure 10.9: Attach Housing to Interface Box
1. Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
2. Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
3. Tighten the two (2) Thumbscrews to secure the Interface Box to the housing.
Figure 10.10: In-Ceiling Housing and Interface Box
1
Interface Box 4 Thumb Screw
2 Ball Stud 5 Tether Point
3 In-ceiling Housing 6 Ceiling Clamp
66 en | Installing the In-Ceiling Mount AUTODOME 7000
2014.04 | 2.0 | F.01U.283.679 Operation Manual Bosch Security Systems, Inc.
To Next Page
Loading...
