Installing the In-Ceiling Mount
Description
This chapter details how to install the camera in an In-Ceiling Mount. The In-Ceiling
AUTODOME camera is suitable for use in environmental air spaces. Refer to Installing the
Pendant Arm Wall, Corner, and Mast (Pole) Mounts, page 25, or refer to Installing the Roof
Parapet and Pipe Mounts, page 41 for these specific installations.
Dimensions
Prepare Drywall Ceiling for Installation
1. Choose the desired location to mount the camera.
2. Use the bracket Base Plate as a template to cut a 7.1 in. hole with a tolerance of ±1/8 in.
(180.34 mm ± 2.2 mm) in the ceiling with a drywall utility saw or Jig Saw. Proceed to Wire
the Interface Box, page 61, for further instructions.
Prepare Suspension Ceiling for Installation
You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1. Choose the desired location to mount the dome, and remove an adjacent ceiling tile.
2. Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
3. Place the Bracket Assembly over the ceiling tile, which is used to mount the camera. Then
snap the Bar Clips of the bracket to the ceiling rails.
Figure 10.1: Suspension Ceiling Bracket (Top View)
1
Suspension Bars 3 Securing Screw (4)
2 Base Plate 4 Bar Clips
1. Use the bracket Base Plate as a template or cut a holesize hole in the center of the ceiling
tile with a drywall utility saw or jig saw.
9
9.1
9.2
9.3
9.4
AUTODOME 7000 Installing the In-Ceiling Mount | en 59
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679
To Next Page
Loading...
