Bosch AUTODOME 7000 VG5-7230 - 11 Connection; Connect Camera to PC

Connection
Connecting the AUTODOME camera to the PC
1. Install the camera according to the instructions in the appropriate Installation section of
this manual.
2. Connect an Ethernet cable from camera’s RJ45 connector to a dedicated network switch
to bypass the Local Area Network (LAN).
3. Connect the dedicated network switch to the RJ45 connector on the PC (see option A
below).
Notice!
The camera can also be connected directly to a PC using an Ethernet crossover cable with
RJ45 connectors (see option B below).
1
2
3
4
1
2
2
4
Figure 12.1: AUTODOME 7000 Series System Configuration
1
AUTODOME 7000 Series
2 IP Connection
3 Network Switch
4 Computer
Notice!
You can also use the Bosch Video Client software application to configure the network
settings for an AUTODOME 7000 Series camera. Go to www.boschsecurity.com to download
the Configuration Manager software and Operating Manual.
Power Cable and Wire Distances Guides
Power
115/230 VAC
Copper Wire To comply with local codes.
11
11.1
11.2
AUTODOME 7000 Connection | en 71
Bosch Security Systems, Inc. Operation Manual 2014.04 | 2.0 | F.01U.283.679