Bosch AUTODOME 7000 VG5-7230 - Installing the VG4-A-9543 Pipe Mount

Figure 9.9: Attach Dome Cap
1
Thread Sealant or tape
2 Dome Cap
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
gaps between the down pipe and the Dome Cap.
12. Proceed to Wire the Pipe Interface Board, page 52.
Notice!
Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
bolt and attach both ends to anchor spots on the roof.
Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to Installing the VGA-ROOF-MOUNT, page 48 for instructions.
Notice!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length
of 5 inches (12.7 cm).
You must use Teflon tape for thread-sealing compound.
All screws shall be tightened securely.
8.5
50 en | Installing the Roof Parapet and Pipe Mounts AUTODOME 7000
2014.04 | 2.0 | F.01U.283.679 Operation Manual Bosch Security Systems, Inc.