en Troubleshooting
40
Fault Cause Troubleshooting
Appliance has a humming
sound.
The blade is blocked or stiff.
Set the rotary switch to .
Remove the blockage.
Appliance switches off dur-
ing use.
Processing quantity is too
great or processing time
was too long.
Set the rotary switch to .
Reduce the processing quantity.
Allow the appliance to cool down to
room temperature.
The programme does not
start.
The rotary switch is not set
to .
Set the rotary switch to .
The programme has been
cancelled using the pro-
gramme button.
1. Set the rotary switch to .
2. Press the programme button for the
required programme.
The To-Go blade insert can-
not be connected to the
base unit.
Outlet protection is active.
Screw the To-Go blade insert and
the To-Go blender jug in by turning
them in a clockwise direction.
a The To-Go blender jug and To-Go
blade insert are fully and tightly
screwed in.
To-Go blender jug is leaking. Seal is missing from the lid.
Insert the seal.
To Next Page
Loading...
