Bosch WAN24058IT - Soaking Laundry; Adding Laundry; Cancelling the Pro- Gramme; Resuming the Programme When the Programme Status Is Rinse Hold

en Basic operation
34
2. Press Fine fra repeatedly until the
display indicates the desired
"Ready in" time.
3. Press Avvio / Agg. bucato.
13.9 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Avvio /
Agg. bucato.
3. To resume the programme, after
the desired soaking time, press
Avvio / Agg. bucato.
13.10 Adding laundry
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Press Avvio / Agg. bucato.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
2. Add or remove laundry.
3. Close the door.
4. Press Avvio / Agg. bucato.
13.11 Cancelling the pro-
gramme
Once the programme has started,
you can cancel it at any time.
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Press Avvio / Agg. bucato.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Risciacquo programme.
– If the water level is high: Start
the Centrifuga or Scarico ac-
qua programme.
3. Remove the laundry.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
1. Set the Centrifuga or Scarico ac-
qua programme.
2. Press Avvio / Agg. bucato.
13.13 Unloading the laundry
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Open the door.
2. Remove the laundry.