Why does my Bosch WAU28T64GB Washer have odours?
If odours have formed in your Bosch washer, leave the door and detergent drawer open when you are not using the appliance. This allows any residual water to evaporate, preventing odour build-up.
What to do if my Bosch Washer is not draining?
If your Bosch washer isn't draining, there could be several reasons: * A power failure might have occurred; in this case, open the door using the emergency release. * The drain pipe or water outlet hose could be blocked; clean them to resolve this. * The drain pipe or water drain hose might be kinked or jammed; ensure they are free from obstructions. * The water outlet hose might be connected too high; install it at a maximum height of 1 meter. * Too much detergent was used; immediately mix one tablespoon of fabric softener with 0.5 liters of water and pour the mixture into the left-hand compartment (not for outdoor clothing, sportswear, or items stuffed with down), and reduce the detergent amount in the next cycle. * An unapproved extension might be installed on the water dra...
Why high spin speed is not reached in my Bosch WAU28T64GB Washer?
If a high spin speed isn't reached or the spin programme doesn't start in your Bosch washer, it may be because a low spin speed is selected. The next time you run a wash cycle, set a higher spin speed.
What to do if the water level is too high in my Bosch WAU28T64GB?
Select a suitable programme for draining.
What to do if my Bosch Washer temperature is too high?
Wait until the temperature has dropped.
What to do if my Bosch Washer water outlet hose is not connected correctly?
Connect the water outlet hose correctly.
What to do if my Bosch WAU28T64GB Washer water outlet hose is damaged?
Replace the damaged water outlet hose.
Why is the display going out and Start/Reload flashing on my Bosch WAU28T64GB Washer?
If the display goes out and Start/Reload flashes on your Bosch washer, it means the energy-saving mode is active. Simply press any button to exit this mode.
How to fix low water pressure in my Bosch WAU28T64GB?
If you're experiencing low water pressure in your Bosch washer, here are a few things to check: * Clean the filters in the water inflow. * Make sure the tap is turned on. * Ensure that the water inlet hose is not kinked or jammed.
What to do if my Bosch WAU28T64GB Washer is not working or starting?
If your Bosch washer isn't working or the program won't start, consider these possibilities: * The power cord's mains plug might not be plugged in; connect the appliance to the power supply. * The circuit breaker in the fuse box could have tripped; check it. * There might have been a power cut; verify if other appliances are working. * You might not have pressed Start/Reload; press it. * The door might not be closed; close it and press Start/Reload. * Finish in might be activated; check if it is.
Covers intended use, user limitations, and general safety advice.
Covers safety at installation sites and the procedure for removing transit bolts.
Instructions for leveling the appliance and connecting it to the power supply.
Procedures for switching off the appliance and activating/deactivating the childproof lock.
A comprehensive guide to identifying and resolving common appliance malfunctions and error codes.
Addresses further error codes (e.g., E:36) and faults like door issues or water not draining.
Troubleshooting for issues with water not flowing in or the spin cycle behaving unusually.
Solutions for variable programme times, appliance vibrations, and operational noises.
Guidance on fixing water leaks from hoses and eliminating appliance odours.
Covers intended use, user limitations, and general safety advice.
Covers safety at installation sites and the procedure for removing transit bolts.
Instructions for leveling the appliance and connecting it to the power supply.
Procedures for switching off the appliance and activating/deactivating the childproof lock.
A comprehensive guide to identifying and resolving common appliance malfunctions and error codes.
Addresses further error codes (e.g., E:36) and faults like door issues or water not draining.
Troubleshooting for issues with water not flowing in or the spin cycle behaving unusually.
Solutions for variable programme times, appliance vibrations, and operational noises.
Guidance on fixing water leaks from hoses and eliminating appliance odours.
General| Current | 10 A |
|---|---|
| Connected load | 2300 W |
| AC input voltage | 220-240 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to G |
| Water consumption per cycle | 44 L |
| Energy consumption washing per cycle | 0.66 kWh |
| Water Plus | No |
| Drum capacity | 9 kg |
| Cycle time (max) | 217 min |
| Delay start (max) | 24 h |
| Spin-drying class | B |
| Maximum spin speed | 1400 RPM |
| Minimum spin speed | 400 RPM |
| Noise level (spin) | 72 dB |
| Noise level (wash) | 48 dB |
| Load balancing system | Yes |
| Number of washing programs | - |
| Cycle time (quick washing program) | 15 min |
| Door color | Grey, White |
| Door hinge | Left |
| Cord length | 2.1 m |
| Drum volume | 63 L |
| Control type | Rotary, Touch |
| Display type | LED |
| Door opening | Side opening |
| Loading type | Front-load |
| Product color | White |
| Door opening angle | 171 ° |
| Appliance placement | Freestanding |
Weight and Dimensions| Depth | 590 mm |
|---|---|
| Width | 598 mm |
| Height | 848 mm |
| Weight | 68300 g |
| Depth with door open | 1063 mm |
To Next Page
