What to do if my Bosch WAX32KH3BY Washer is leaking water at the water inlet hose?
If water is leaking from the water inlet hose of your Bosch washer, make sure that the water supply hose is correctly connected and tighten the screw connection.
What to do if my Bosch WAX32KH3BY is not draining water?
If your Bosch washer isn't draining water, it could be due to: * The temperature is too high. Wait until the temperature has dropped. * Water level is too high. Select a suitable programme for draining.
What to do if my Bosch Washer has detergent residue on the damp washing?
If you find detergent residue on your damp washing in your Bosch washer, it could be due to a few reasons: * A low spin speed was selected. Set a higher spin speed for the next wash cycle. * The drain pipe or water outlet hose is blocked. Clean the drain pipe and the water outlet hose. * The drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe and water drain hose are not kinked or trapped. * The unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed. Redistribute the laundry in the drum. You can also start the Spin programme.
How to fix creasing in my Bosch Washer?
If you're experiencing creasing with your Bosch washer, here's what you can do: * The spin speed is too high. Set a lower spin speed for the next wash cycle. * The load is too large. Reduce the amount of laundry being loaded for the next wash cycle. * Unsuitable programme for the type of fabric. Select the programmes that are suitable for the type of fabric.
What to do if the pump for the intelligent dosing system is blocked on my Bosch Washer?
If the pump for the intelligent dosing system is blocked on your Bosch washer: 1. Switch off the appliance. 2. Clean the pump unit.
What to do if the water filter in the water inflow is blocked in my Bosch Washer?
If the water filter in the water inflow is blocked, clean the water inflow filter.
What to do if the water inlet hose is kinked or jammed in my Bosch Washer?
If the water inlet hose is kinked or jammed, ensure that the water inlet hose is not kinked or jammed.
What to do if the water outlet hose is damaged on my Bosch WAX32KH3BY Washer?
Replace the damaged water outlet hose.
What to do if the water outlet hose is not connected correctly on my Bosch Washer?
Connect the water outlet hose correctly.
What does error E:10 / -00 / -10 / -20 mean on Bosch Washer?
The error code E:10 / -00 / -10 / -20 on your Bosch washer indicates that the pump for the intelligent dosing system is blocked. To resolve this: 1. Switch off the appliance. 2. Clean the pump unit. 3. If this display appears again, call customer service.
General| Capacity | 9 kg |
|---|---|
| Energy Efficiency Class | A |
| Spin Speed | 1600 RPM |
| Noise Level Spinning | 74 dB |
| Child Lock | Yes |
| Drum Material | Stainless Steel |
| Type | Front Load |
| Dimensions (H x W x D) | 84.8 x 59.8 x 59.0 cm |
| Programs | Delicates, Drum Clean, Wool/Hand wash |
| Delay Start | Yes |
| Display | LED |
| Motor Type | EcoSilence Drive |
To Next Page
