Bosch WAX32MH2BY - Home Connect; Connecting the Appliance to a WLAN Home Network (Wi-Fi) with WPS Function; Connecting the Appliance to a WLAN Home Network (Wi-Fi) Without WPS Func- Tion

HomeConnect en
33
served when operating the appli-
ance via the HomeConnect app.
→"Safety", Page4
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
HomeConnect app.
15.1 Connecting the appli-
ance to a WLAN home
network (Wi-Fi) with
WPS function
Requirements
¡ Your router has a WPS function.
¡ Wi-Fi is activated on the router.
¡ The Wi-Fi basic setting is activated
on the appliance.
→"Activating Wi-Fi on the appli-
ance", Page34
¡ The appliance receives signals
from the WLAN home network (Wi-
Fi) at its installation location.
¡ The HomeConnect app is installed
on your mobile device.
1. Press and hold RemoteStart for
at least 3seconds.
a The display shows Aut.
2. Press Start/Reload .
3. Press the WPS button on the
router within the next 2minutes.
Take note of the information in the
documents for your router.
a flashes on the display.
a The device connects to the Wi-Fi
home network.
a If the display shows con and
lights up permanently, the appli-
ance is connected to the Wi-Fi
home network.
4. If the appliance is not connected
to the Wi-Fi home network, the dis-
play shows Err.
‒ Check whether the appliance is
within the range of the Wi-Fi
home network.
‒ Reconnect the appliance to the
Wi-Fi home network with WPS
function.
5. Connect the appliance to the
Home Connect app. →Page34
15.2 Connecting the appli-
ance to a WLAN home
network (Wi-Fi) without
WPS function
If your router does not have a WPS
function, you can connect the appli-
ance to your WLAN home network
(Wi-Fi) manually.
Requirements
¡ Wi-Fi is activated on the router.
¡ The Wi-Fi basic setting is activated
on the appliance.
→"Activating Wi-Fi on the appli-
ance", Page34
¡ The appliance receives signals
from the WLAN home network (Wi-
Fi) at its installation location.
¡ The HomeConnect app is installed
on your mobile device.
1. Press and hold RemoteStart for
at least 3seconds.
a The display shows Aut.
2. Set the programme to position2.
a The display shows SAP.
3. Press Start/Reload .
a flashes on the display.
a The appliance now sets up its own
Wi-Fi home network with the name
(SSID) HomeConnect.
4. Call up the Wi-Fi settings on the
mobile device.