Bosch WAX32MH2BY - Page 44

en Troubleshooting
44
Fault Cause and troubleshooting
The programme does
not start.
▶
→"Deactivating the childproof lock", Page32
-Finished in ⁠+ is activated.
▶
Check whether -Finished in ⁠+ is activated.
→"Buttons", Page22
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Start/Reload to start the programme.
The door cannot
beopened.
is activated.
▶
Continue the programme by selecting ⁠Spin or
⁠Drain and pressing Start/Reload .
→"Resuming the programme when the programme
status is Rinse Hold", Page31
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page31
Water level is too high.
▶
Select a suitable programme for draining.
→"Programmes", Page24
Power failure.
▶
Open the door using the emergency release.
→"Emergency release", Page50
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
→"Cleaning the drain pump", Page37
is activated.
▶
Continue the programme by selecting ⁠Spin or
⁠Drain and pressing Start/Reload .
→"Resuming the programme when the programme
status is Rinse Hold", Page31
The water outlet hose is connected too high.
▶
Install the water outlet hose at a maximum height of
1 metre.
Pump cover is not correctly assembled.