37
Information on the display panel
Display Cause/Remedy
²»¾Â´ ³¾¾Á
– Washing may be caught. Please open and close washing
machine door again and select Avvio/Aggiungi bucato (Start/
Reload)
A.
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
»¾ËÆ Æ°Ã´Á
¿Á´ÂÂÄÁ´
¾¿´½
̡– Turn on tap fully.
–Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 35
¿Ä¼¿ ¸Â ±»¾²º´³
²»´°½
¿Ä¼¿
– Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 34
³¾¾Á ¸Â »¾²º´³
Water level or temperature is too high.
Select Avvio/Aggiungi bucato (Start/Reload)
A to continue the
programme.
»¾²º¸½¶...
Ľ»¾²º¸½¶...
If the Start/Reload
A button is pressed too frequently
(e.g. repeatedly reloading items of washing), the door lock may
overheat. Wait for the door lock to lock or unlock.
´: ÌÍ
not applicable without AquaStop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 40
Error
´: XXX
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 40
To Next Page
Loading...
