36
²
– When the i-DOS i/w container content is switched from
softener to detergent, the basic dosage amount of detergent
for this container is set to the factory setting (75 ml) and the
dosage for this detergent is set to off in all permitted
programmes. Then select the detergent dosage (light, normal
or strong) via the i-DOS i/w button on the display panel.
~ Page 17
The i-DOS w container is automatically deactivated if the
detergent dosage is activated for the i-DOS i/w container.
The settings are retained for this programme until the next
change.
– When thei-DOS i/w container content is switched to
softener, the basic dosage amount is set to factory setting
(36 ml) and the dosage is set to normal in all permitted
programmes.
– Switching over the container contents requires an additional
acknowledgement via the display panel.
i A change to the i-DOS content
resets the i-DOS
i/w settings
to their standard value.
Cancel Continue
To Next Page
