65
Transportation
Preparatory work
1.
Turn off the tap.
2.
Release the water pressure in the supply hose. Maintenance
– Filter in the water inlet hose ~ Page 46
3.
Drain any residual detergent solution. Maintenance – Drain
pump blocked ~ Page 44
4.
Isolate the washing machine from the power supply.
5.
Remove the hoses.
6.
Drain dispensers. ~ Page 42
Installing transportation protection devices
1.
Remove covers and keep in a safe place.
If required, use a screwdriver.
2.
Insert all 4 sleeves.
Clamp mains cable on the holders. Insert and tighten the
bolts.
Before switching on the appliance:
²
– Always remove the transportation protection devices!
~ Page 57
– To prevent unused detergent from flowing into the outlet
during the next wash cycle: Pour 1 litre of water into
dispenser u v and start the Drain programme.
To Next Page
Loading...
