Bosch WDU8H541GB/01 - Basic Operation; Switching on the Appliance; Setting a Programme; Adjusting the Programme Settings

operation en
31
¡ Do not mix detergent and fabric
softener
¡ Do not use products that have ex-
pired or are highly congealed
¡ do not use products containing
solvents, caustic agents or volatile
substances
¡ Use dyes sparingly as salt may
damage stainless steel
¡ Do not use color-bleaching agents
in the appliance
operation
14 Basic operation
operation
14.1 Switching on the appli-
ance
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page12
▶ Press ⁠ .
The switch-on process takes a few
seconds.
Note:The lighting for the drum goes
out automatically.
14.2 Setting a programme
1. Turn the programme selector and
set the required programme.
→"Programmes", Page26
2. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page31
14.3 Adjusting the pro-
gramme settings
Requirement:A programme is set.
→"Setting a programme", Page31
▶ Adjust the programme settings.
→"Buttons", Page22
Observe the information about op-
erating logic →Page18.
Note:The programme settings are
not saved permanently for the pro-
gramme.
14.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→"Setting a programme",
Page31
¡ The programme settings have
been adjusted.
→"Adjusting the programme set-
tings", Page31
▶ Press and hold ⁠ for approx. 3
seconds.
Press ⁠ to call up the saved pro-
gramme.
Note:To overwrite the saved pro-
gramme, repeat the steps above.
14.5 Loading laundry
Note:To prevent creasing, note the
maximum load for the programmes.
→"Programmes", Page26
Requirements
¡ The laundry is prepared and sor-
ted.
→"Laundry", Page30
¡ The drum is empty.
1. Open the door.
2. Place the laundry in the drum.
3. Close the door.
Ensure that there is no laundry
trapped in the door.