Bosch WDU8H541GB/01 - Starting the Programme; Soaking Laundry; Adding Laundry; Cancelling the Washing Programme

operation en
33
14.9 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page31
1. Press ⁠ .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
2. If the display shows ⁠ , the laun-
dry is not spun. The water is
pumped out after the rinse cycle.
Note:If you do not remove the laun-
dry once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0:00
and ⁠ .
Press anywhere on the display to
cancel the crease-reduction pro-
gramme and to remove the laundry.
14.10 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press ⁠ .
3. To resume the programme, after
the desired soaking time, press
⁠ .
14.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press ⁠ .
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page21
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press ⁠ .
14.12 Cancelling the washing
programme
1. Press ⁠ .
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select
a suitable programme for drain-
ing.
→"Programmes", Page26
3. Remove the laundry.
→"Unloading the laundry",
Page33
14.13 Cancelling the drying
programme
1. Press ⁠ .
a The appliance switches off.
2. Switch the appliance on again.
3. To start the cooling process: Se-
lect the My Time+Dry pro-
gramme.
4. Press ⁠ .
14.14 Unloading the laundry
1. Open the door.