Bosch WDU8H542ES - Page 44

en Troubleshooting
44
Fault Cause and troubleshooting
⁠ The filter in the water inflow is blocked.
▶ Clean the water inflow filter.
The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.
"E:35 / -10" There is water in the base trough.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
The appliance is leaking.
▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page53
⁠ lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page34
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page26
⁠ Detergent dosage is too high.
▶ Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
"H:95" lights up altern-
ately with End.
The water pressure is low.
▶ See
→" ⁠ ", Page44
All other error codes. Malfunction
▶ Call the after-sales service.
→"Customer Service", Page53
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶ Check the circuit breaker in the fuse box.
There has been a power cut.