Bosch WDU8H542SN - Detergents and Care; Products; Basic Operation; Switching on the Appliance

en Detergents and care products
32
13 Detergents and care
products
Notes
¡ You can find further information in
the digital instruction manual by
scanning the QR code in the table
of contents or on www.bosch-
home.com.
¡ Observe the information on safety
→Page4 and preventing material
damage →Page11.
The manufacturer's instructions for
use and dosage can be found on the
packaging.
Notes
¡ Only use liquid detergents that are
self-flowing
¡ Do not mix different liquid deter-
gents
¡ Do not mix detergent and fabric
softener
¡ Do not use products that have ex-
pired or are highly congealed
¡ Use dyes sparingly as salt may
damage stainless steel
¡ Do not use bleaching agents in the
appliance
operation
14 Basic operation
operation
Note:You can find further information
in the digital instruction manual by
scanning the QR code in the table of
contents or on www.bosch-
home.com.
14.1 Switching on the appli-
ance
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page13
▶ Press ⁠ .
The switch-on process takes a few
seconds.
Note:The lighting for the drum goes
out automatically.
14.2 Setting a programme
1. Turn the programme selector and
set the required programme.
→"Programmes", Page27
2. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page32
14.3 Adjusting the pro-
gramme settings
Requirement:A programme is set.
→"Setting a programme", Page32
▶ Adjust the programme settings.
→"Buttons", Page23
Observe the information about op-
erating logic →Page19.
Note:The programme settings are
not saved permanently for the pro-
gramme.
14.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→"Setting a programme",
Page32
¡ The programme settings have
been adjusted.
→"Adjusting the programme set-
tings", Page32
▶ Press and hold ⁠ for approx. 3
seconds.