en operation
34
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
14.8 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page32.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
14.9 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page32
1. Press .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: End.
2. If is selected, the laundry is not
spun and the water is drained after
rinsing.
Note:If you do not remove the laun-
dry once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0:00
and .
Press anywhere on the display to
cancel the crease-reduction pro-
gramme and to remove the laundry.
14.10 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press .
3. To resume the programme, after
the desired soaking time, press
.
14.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:A programme has
started.
→"Starting the programme",
Page34
1. Press .
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the door.
3. Add or remove laundry.
To Next Page
Loading...
