Positioning and connecting en
21
b) Insert and tighten the screws.
c) Clip the hoses securely in the
holders.
Before switching on the appliance
again:
Notes
■ The support struts must be
removed.
~ "Removing the support struts"
on page 15
■ The transport braces must be
removed.
~ "Removing the transport locks"
on page 14
■ Pour approx. 1 litre of water into
dispenser II, select the Drain
programme and start.
This will prevent detergent from
flowing straight into the drain during
the next wash.
To Next Page
Loading...
