Bosch WNA144V9GB - Troubleshooting Common Issues; Damp Laundry and Detergent Residue Solutions

Troubleshooting en
47
Fault Cause and troubleshooting
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
▶ Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶ Start the Spinprogramme.
Detergent residue on
the damp washing.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶ Start the Rinse programme.
Detergent residue on
the dry laundry.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶ Brush out the laundry after washing and drying.
Water is leaking out at
the water inlet hose.
Water inlet hose is not correctly/securely connected.
1. Connect the water supply hose correctly.
→"Connecting the water inlet hose", Page15
2. Tighten the screw connection.
Water is leaking out at
the water outlet hose.
The water outlet hose is damaged.
▶ Replace the damaged water outlet hose.
Water outlet hose is not connected correctly.
▶ Connect the water outlet hose correctly.
→"Water outlet connection types", Page16
Fluff on the laundry. Fluff has accumulated in the drum.
▶ Run the Cottons ⁠90° programme without any
laundry or detergent.
Water inlet noise dur-
ing the drying phase.
Drying phase requires water.
1. Not a fault.
2. Make sure that the water tap also remains open
during the drying phase.
Drying programme
does not start.
Door is not closed.
1. Close the door.
2. Press ⁠Start/ Reload to start the programme.
No drying programme is selected.
▶ Select a suitable drying programme.
→"Programmes", Page26
The laundry is too
damp.
Unsuitable programme for the type of fabric.
There has been a power cut.
▶ Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.