Cleaning and servicing en
37
1. Open the maintenance flap.
If you place a cloth beneath the
maintenance flap, you can collect
the remaining water from the base
unit.
2. Open the lever for the heat ex-
changer cover.
3. Pull out the heat exchanger cover
by the handle.
Cleaning the base unit
You can remove any visible dirt in the
base unit.
CAUTION
Risk of cutting!
Touching sharp edges on the heat
exchanger may lead to cuts.
▶
Do not touch the fins on the heat
exchanger.
1.
Open the base unit →Page36.
2. Use a soft brush to clean the heat
exchanger cover.
Make sure that you remove all dirt
from the seal.
3. Lift the middle tab on the insert
slightly.
To Next Page
Loading...
Need help?
General
