[-_Do not damage the air cooler!
Clean with warm water only; do
not use hard/sharp-edged
objects!
7. Clean the air cooler completely,
drain thoroughly.
8. Clean the seals.
Cleaning the moisture
sensor
Occasionally the moisture sensor
has to be cleaned because a fine
layer of transparent buildup is
deposited on the sensors.
C
Changing the light
bulb
The dryer light turns on inside the
drum when you open the door.
To change the light bulb:
1. Turn off the circuit breaker.
2. Pull out power supply plug.
3. Open the door and locate the
light bulb on the upper center
of the seal.
9. Re-insert the air cooler, handle
at the bottom!
10. Unscrew both locking levers.
1. Close the maintenance flap
until it locks into position.
This deposit can easily be removed
by wiping the sensors (the two bars
next to the lint filter) with a cloth and
a little white vinegar.
Use white vinegar only!
Clean the moisture sensor once
a month.
Cleaning the bearing
shield
Over time, fluff from the drying
process collects in the bearing
shield
4. Loosen the screw of the cover
and open the cover.
5. Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through customer service).
6. Replace the cover and secure
with the screw.
7_
Plug in dryer or reconnect
power supply.
This fluff can be easily removed
using your vacuum cleaner, at least
once a month.
2O
To Next Page
Loading...
