Bosch WVG30441EU - Reloading the Laundry; Changing the Programme; Interrupting or Ending the Programme; End of the Programme

en Operating the appliance
18
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Touch the Start/Reload
A button. The
washer dryer checks whether reloading
is possible.
Notes
■ If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
Õ is lit ~ Reloading is not
possible. To continue the
programme, select the
Start/Reload
A button.
■ Do not open the door until the door
lock symbol Õ goes out.
■ Do not leave door open for
a prolonged period – water could
run out of the laundry.
■ The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Select Start/Reload
A.
2. Select another programme. If
required, adjust the default settings
and/or select additional functions.
3. Select Start/Reload
A. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1. Select Start/Reload
A.
2. To cool down laundry: Select Rinse
O.
3. Select Start/Reload
A.
For programmes at low temperature:
1. Select Start/Reload
A.
2. Select or Spin/Empty 0/[.
3. Select Start/Reload
A.
For drying programmes:
1. Select Intensive Dry 5 or Gentle
Dry ‰.
2. Touch button 5 Dry and set drying
time to 15 minutes.
3. Select Start/Reload
A.
End of the programme
End or – – – – (Rinse stop = without
final drain/spin cycle) is indicated in the
display and acoustic signal sounds.
Setting the signal~ Page 27
If – – – – (Rinse stop = without final
drain/spin cycle) was selected, press
Start/Reload
A button to start the final
drain/spin cycle.
Notes
■ The programme continues by
pumping out the water and spinning
the laundry (the standard spin speed
can be changed beforehand).
■ If only the water is to be pumped out,
approx. 1 minute after the
programme starts, touch the Start/
Reload
A button before the spin
cycle starts. The programme is
interrupted and the door lock is
released. The laundry can be
removed.