Connecting the optional IR
emitter
cable
The
IR
(infrared) emitter cable
is
designed for optional use with system components that are
connected
to
the media center, but placed where they cannot receive
IR
signals from it. This
can resolve the problem when a particular component does not respond
to
LIFESTYLE®
remote control commands.
By plugging
an
emitter into the media center and placing it near the component, you can
make sure that the
LIFESTYLE®
remote control signals reach that component.
To
use the emitter:
1.
Insert the 3.5 mm plug into the
IR
EMITIER jack on the rear of the media center
(Figure 24).
Figure
24
OptionallR emitter cable
connection to the media
center
2.
Place the flat side at the other end
of
the cable against the
IR
receiver window on the
front
of
the component.
Note: There is a
procedure
you
must
follow to
program
the
LIFESTYLEBJ
remote so that it
works with
your
other components. Refer to the
LIFESTYLEBJ
Operating Guide for details on
how
to
do
that.
3.
Confirm that
IR
signals now work
to
control that component. Move the emitter around, as
necessary, to find the best position.
4.
Use the double-sided tape enclosed with the emitter
to
affix it
in
the proper position.
J Note:
If
you have questions,
or
need
to
obtain a replacement emitter,
contact
Bost? cus-
tomer service. Refer to the Bose address list
included
with
your
system.
Accessories
For information on speaker mounting brackets and stands, additional remote controls, and
connecting additional Bose powered loudspeakers, contact your Bose dealer or call Bose
customer service.
Warranty
Your
LIFESTYLE®
home entertainment system
is
covered by a transferable limited warranty.
See your warranty card for details. Please be sure
to
fill out the information section on the
card and mail it to Bose.
Contacting customer service
For additional help
in
solving problems, contact Bose customer service. See the address and
phone number list provided with your system.
26
To Next Page
Loading...
